IMPORTANT - Factory Reset After SBC1000 Upgrade

Please be aware that an issue has emerged with upgrading certain SBC1000 devices where the SBC will apply a factory default configuration after an upgrade. This means unless DHCP is enabled on the network you'll need to physically connect to the SBC to re-run the initial IP setup
Upgrading to 5.0.4v414 will resolve this problem. Use this version as a stepping stone to 6.x
This does NOT apply to SBC2000

NOTE: If you cannot see any files in this section it is either because you have not logged in or you do not currently have permission to access this area. Please fill in the download request form after you have logged in.

Up

SBC 1000